/*
* linux/arch/arm/mach-omap1/sleep.S
*
* Low-level OMAP7XX/1510/1610 sleep/wakeUp support
*
* Initial SA1110 code:
* Copyright (c) 2001 Cliff Brake <[email protected]>
*
* Adapted for PXA by Nicolas Pitre:
* Copyright (c) 2002 Monta Vista Software, Inc.
*
* Support for OMAP1510/1610 by Dirk Behme <[email protected]>
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of the GNU General Public License as published by the
* Free Software Foundation; either version 2 of the License, or (at your
* option) any later version.
*
* THIS SOFTWARE IS PROVIDED ``AS IS'' AND ANY EXPRESS OR IMPLIED
* WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN
* NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
* NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF
* USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON
* ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
* THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*
* You should have received a copy of the GNU General Public License along
* with this program; if not, write to the Free Software Foundation, Inc.,
* 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#include <linux/linkage.h>
#include <asm/assembler.h>
#include "hardware.h"
#include "iomap.h"
#include "pm.h"
.text
/*
* Forces OMAP into deep sleep state
*
* omapXXXX_cpu_suspend()
*
* The values of the registers ARM_IDLECT1 and ARM_IDLECT2 are passed
* as arg0 and arg1 from caller. arg0 is stored in register r0 and arg1
* in register r1.
*
* Note: This code get's copied to internal SRAM at boot. When the OMAP
* wakes up it continues execution at the point it went to sleep.
*
* Note: Because of errata work arounds we have processor specific functions
* here. They are mostly the same, but slightly different.
*
*/
#ifdef CONFIG_ARCH_OMAP15XX
.align 3
ENTRY(omap1510_cpu_suspend)
@ save registers on stack
stmfd sp!, {r0 - r12, lr}
@ load base address of Traffic Controller
mov r4, #TCMIF_ASM_BASE & 0xff000000
orr r4, r4, #TCMIF_ASM_BASE & 0x00ff0000
orr r4, r4, #TCMIF_ASM_BASE & 0x0000ff00
@ work around errata of OMAP1510 PDE bit for TC shut down
@ clear PDE bit
ldr r5, [r4, #EMIFS_CONFIG_ASM_OFFSET & 0xff]
bic r5, r5, #PDE_BIT & 0xff
str r5, [r4, #EMIFS_CONFIG_ASM_OFFSET & 0xff]
@ set PWD_EN bit
and r5, r5, #PWD_EN_BIT & 0xff
str r5, [r4, #EMIFS_CONFIG_ASM_OFFSET & 0xff]
@ prepare to put SDRAM into self-refresh manually
ldr r5, [r4, #EMIFF_SDRAM_CONFIG_ASM_OFFSET & 0xff]
orr r5, r5, #SELF_REFRESH_MODE & 0xff000000
orr r5, r5, #SELF_REFRESH_MODE & 0x000000ff
str r5, [r4, #EMIFF_SDRAM_CONFIG_ASM_OFFSET & 0xff]
@ prepare to put EMIFS to Sleep
ldr r5, [r4, #EMIFS_CONFIG_ASM_OFFSET & 0xff]
orr r5, r5, #IDLE_EMIFS_REQUEST & 0xff
str r5, [r4, #EMIFS_CONFIG_ASM_OFFSET & 0xff]
@ load base address of ARM_IDLECT1 and ARM_IDLECT2
mov r4, #CLKGEN_REG_ASM_BASE & 0xff000000
orr r4, r4, #CLKGEN_REG_ASM_BASE & 0x00ff0000
orr r4, r4, #CLKGEN_REG_ASM_BASE & 0x0000ff00
@ turn off clock domains
mov r5, #OMAP1510_IDLE_CLOCK_DOMAINS & 0xff
orr r5, r5, #OMAP1510_IDLE_CLOCK_DOMAINS & 0xff00
strh r5, [r4, #ARM_IDLECT2_ASM_OFFSET & 0xff]
@ request ARM idle
mov r3, #OMAP1510_DEEP_SLEEP_REQUEST & 0xff
orr r3, r3, #OMAP1510_DEEP_SLEEP_REQUEST & 0xff00
strh r3, [r4, #ARM_IDLECT1_ASM_OFFSET & 0xff]
mov r5, #IDLE_WAIT_CYCLES & 0xff
orr r5, r5, #IDLE_WAIT_CYCLES & 0xff00
l_1510_2:
subs r5, r5, #1
bne l_1510_2
/*
* Let's wait for the next wake up event to wake us up. r0 can't be
* used here because r0 holds ARM_IDLECT1
*/
mov r2, #0
mcr p15, 0, r2, c7, c0, 4 @ wait for interrupt
/*
* omap1510_cpu_suspend()'s resume point.
*
* It will just start executing here, so we'll restore stuff from the
* stack, reset the ARM_IDLECT1 and ARM_IDLECT2.
*/
strh r1, [r4, #ARM_IDLECT2_ASM_OFFSET & 0xff]
strh r0, [r4, #ARM_IDLECT1_ASM_OFFSET & 0xff]
@ restore regs and return
ldmfd sp!, {r0 - r12, pc}
ENTRY(omap1510_cpu_suspend_sz)
.word . - omap1510_cpu_suspend
#endif /* CONFIG_ARCH_OMAP15XX */
#if defined(CONFIG_ARCH_OMAP16XX)
.align 3
ENTRY(omap1610_cpu_suspend)
@ save registers on stack
stmfd sp!, {r0 - r12, lr}
@ Drain write cache
mov r4, #0
mcr p15, 0, r0, c7, c10, 4
nop
@ Load base address of Traffic Controller
mov r6, #TCMIF_ASM_BASE & 0xff000000
orr r6, r6, #TCMIF_ASM_BASE & 0x00ff0000
orr r6, r6, #TCMIF_ASM_BASE & 0x0000ff00
@ Prepare to put SDRAM into self-refresh manually
ldr r7, [r6, #EMIFF_SDRAM_CONFIG_ASM_OFFSET & 0xff]
orr r9, r7, #SELF_REFRESH_MODE & 0xff000000
orr r9, r9, #SELF_REFRESH_MODE & 0x000000ff
str r9, [r6, #EMIFF_SDRAM_CONFIG_ASM_OFFSET & 0xff]
@ Prepare to put EMIFS to Sleep
ldr r8, [r6, #EMIFS_CONFIG_ASM_OFFSET & 0xff]
orr r9, r8, #IDLE_EMIFS_REQUEST & 0xff
str r9, [r6, #EMIFS_CONFIG_ASM_OFFSET & 0xff]
@ Load base address of ARM_IDLECT1 and ARM_IDLECT2
mov r4, #CLKGEN_REG_ASM_BASE & 0xff000000
orr r4, r4, #CLKGEN_REG_ASM_BASE & 0x00ff0000
orr r4, r4, #CLKGEN_REG_ASM_BASE & 0x0000ff00
@ Turn off clock domains
@ Do not disable PERCK (0x04)
mov r5, #OMAP1610_IDLECT2_SLEEP_VAL & 0xff
orr r5, r5, #OMAP1610_IDLECT2_SLEEP_VAL & 0xff00
strh r5, [r4, #ARM_IDLECT2_ASM_OFFSET & 0xff]
@ Request ARM idle
mov r3, #OMAP1610_IDLECT1_SLEEP_VAL & 0xff
orr r3, r3, #OMAP1610_IDLECT1_SLEEP_VAL & 0xff00
strh r3, [r4, #ARM_IDLECT1_ASM_OFFSET & 0xff]
/*
* Let's wait for the next wake up event to wake us up. r0 can't be
* used here because r0 holds ARM_IDLECT1
*/
mov r2, #0
mcr p15, 0, r2, c7, c0, 4 @ wait for interrupt
@ Errata (HEL3SU467, section 1.4.4) specifies nop-instructions
@ according to this formula:
@ 2 + (4*DPLL_MULT)/DPLL_DIV/ARMDIV
@ Max DPLL_MULT = 18
@ DPLL_DIV = 1
@ ARMDIV = 1
@ => 74 nop-instructions
nop
nop
nop
nop
nop
nop
nop
nop
nop
nop @10
nop
nop
nop
nop
nop
nop
nop
nop
nop
nop @20
nop
nop
nop
nop
nop
nop
nop
nop
nop
nop @30
nop
nop
nop
nop
nop
nop
nop
nop
nop
nop @40
nop
nop
nop
nop
nop
nop
nop
nop
nop
nop @50
nop
nop
nop
nop
nop
nop
nop
nop
nop
nop @60
nop
nop
nop
nop
nop
nop
nop
nop
nop
nop @70
nop
nop
nop
nop @74
/*
* omap1610_cpu_suspend()'s resume point.
*
* It will just start executing here, so we'll restore stuff from the
* stack.
*/
@ Restore the ARM_IDLECT1 and ARM_IDLECT2.
strh r1, [r4, #ARM_IDLECT2_ASM_OFFSET & 0xff]
strh r0, [r4, #ARM_IDLECT1_ASM_OFFSET & 0xff]
@ Restore EMIFF controls
str r7, [r6, #EMIFF_SDRAM_CONFIG_ASM_OFFSET & 0xff]
str r8, [r6, #EMIFS_CONFIG_ASM_OFFSET & 0xff]
@ Restore regs and return
ldmfd sp!, {r0 - r12, pc}
ENTRY(omap1610_cpu_suspend_sz)
.word . - omap1610_cpu_suspend
#endif /* CONFIG_ARCH_OMAP16XX */
Codebase Browser
linux