linux/drivers/net/ethernet/asix/Kconfig

#
# Asix network device configuration
#

config NET_VENDOR_ASIX
	bool "Asix devices"
	default y
	help
	  If you have a network (Ethernet, non-USB, not NE2000 compatible)
	  interface based on a chip from ASIX, say Y.

if NET_VENDOR_ASIX

config SPI_AX88796C
	tristate "Asix AX88796C-SPI support"
	select PHYLIB
	depends on SPI
	depends on GPIOLIB
	help
	  Say Y here if you intend to use ASIX AX88796C attached in SPI mode.

config SPI_AX88796C_COMPRESSION
	bool "SPI transfer compression"
	default n
	depends on SPI_AX88796C
	help
	  Say Y here to enable SPI transfer compression. It saves up
	  to 24 dummy cycles during each transfer which may noticeably
	  speed up short transfers. This sets the default value that is
	  inherited by network interfaces during probe. It can be
	  changed at run time via spi-compression ethtool tunable.

	  If unsure say N.

endif # NET_VENDOR_ASIX