=================
SPI NOR framework
=================
How to propose a new flash addition
-----------------------------------
Most SPI NOR flashes comply with the JEDEC JESD216
Serial Flash Discoverable Parameter (SFDP) standard. SFDP describes
the functional and feature capabilities of serial flash devices in a
standard set of internal read-only parameter tables.
The SPI NOR driver queries the SFDP tables in order to determine the
flash's parameters and settings. If the flash defines the SFDP tables
it's likely that you won't need a flash entry at all, and instead
rely on the generic flash driver which probes the flash solely based
on its SFDP data. All one has to do is to specify the "jedec,spi-nor"
compatible in the device tree.
There are cases however where you need to define an explicit flash
entry. This typically happens when the flash has settings or support
that is not covered by the SFDP tables (e.g. Block Protection), or
when the flash contains mangled SFDP data. If the later, one needs
to implement the ``spi_nor_fixups`` hooks in order to amend the SFDP
parameters with the correct values.
Minimum testing requirements
-----------------------------
Do all the tests from below and paste them in the commit's comments
section, after the ``---`` marker.
1) Specify the controller that you used to test the flash and specify
the frequency at which the flash was operated, e.g.::
This flash is populated on the X board and was tested at Y
frequency using the Z (put compatible) SPI controller.
2) Dump the sysfs entries and print the md5/sha1/sha256 SFDP checksum::
root@1:~# cat /sys/bus/spi/devices/spi0.0/spi-nor/partname
sst26vf064b
root@1:~# cat /sys/bus/spi/devices/spi0.0/spi-nor/jedec_id
bf2643
root@1:~# cat /sys/bus/spi/devices/spi0.0/spi-nor/manufacturer
sst
root@1:~# xxd -p /sys/bus/spi/devices/spi0.0/spi-nor/sfdp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root@1:~# sha256sum /sys/bus/spi/devices/spi0.0/spi-nor/sfdp
428f34d0461876f189ac97f93e68a05fa6428c6650b3b7baf736a921e5898ed1 /sys/bus/spi/devices/spi0.0/spi-nor/sfdp
Please dump the SFDP tables using ``xxd -p``. It enables us to do
the reverse operation and convert the hexdump to binary with
``xxd -rp``. Dumping the SFDP data with ``hexdump -Cv`` is accepted,
but less desirable.
3) Dump debugfs data::
root@1:~# cat /sys/kernel/debug/spi-nor/spi0.0/capabilities
Supported read modes by the flash
1S-1S-1S
opcode 0x03
mode cycles 0
dummy cycles 0
1S-1S-1S (fast read)
opcode 0x0b
mode cycles 0
dummy cycles 8
1S-1S-2S
opcode 0x3b
mode cycles 0
dummy cycles 8
1S-2S-2S
opcode 0xbb
mode cycles 4
dummy cycles 0
1S-1S-4S
opcode 0x6b
mode cycles 0
dummy cycles 8
1S-4S-4S
opcode 0xeb
mode cycles 2
dummy cycles 4
4S-4S-4S
opcode 0x0b
mode cycles 2
dummy cycles 4
Supported page program modes by the flash
1S-1S-1S
opcode 0x02
root@1:~# cat /sys/kernel/debug/spi-nor/spi0.0/params
name sst26vf064b
id bf 26 43 bf 26 43
size 8.00 MiB
write size 1
page size 256
address nbytes 3
flags HAS_LOCK | HAS_16BIT_SR | SOFT_RESET | SWP_IS_VOLATILE
opcodes
read 0xeb
dummy cycles 6
erase 0x20
program 0x02
8D extension none
protocols
read 1S-4S-4S
write 1S-1S-1S
register 1S-1S-1S
erase commands
20 (4.00 KiB) [0]
d8 (8.00 KiB) [1]
d8 (32.0 KiB) [2]
d8 (64.0 KiB) [3]
c7 (8.00 MiB)
sector map
region (in hex) | erase mask | flags
------------------+------------+----------
00000000-00007fff | [01 ] |
00008000-0000ffff | [0 2 ] |
00010000-007effff | [0 3] |
007f0000-007f7fff | [0 2 ] |
007f8000-007fffff | [01 ] |
4) Use `mtd-utils <https://git.infradead.org/mtd-utils.git>`__
and verify that erase, read and page program operations work fine::
root@1:~# dd if=/dev/urandom of=./spi_test bs=1M count=2
2+0 records in
2+0 records out
2097152 bytes (2.1 MB, 2.0 MiB) copied, 0.848566 s, 2.5 MB/s
root@1:~# mtd_debug erase /dev/mtd0 0 2097152
Erased 2097152 bytes from address 0x00000000 in flash
root@1:~# mtd_debug read /dev/mtd0 0 2097152 spi_read
Copied 2097152 bytes from address 0x00000000 in flash to spi_read
root@1:~# hexdump spi_read
0000000 ffff ffff ffff ffff ffff ffff ffff ffff
*
0200000
root@1:~# sha256sum spi_read
4bda3a28f4ffe603c0ec1258c0034d65a1a0d35ab7bd523a834608adabf03cc5 spi_read
root@1:~# mtd_debug write /dev/mtd0 0 2097152 spi_test
Copied 2097152 bytes from spi_test to address 0x00000000 in flash
root@1:~# mtd_debug read /dev/mtd0 0 2097152 spi_read
Copied 2097152 bytes from address 0x00000000 in flash to spi_read
root@1:~# sha256sum spi*
c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_read
c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_test
If the flash comes erased by default and the previous erase was ignored,
we won't catch it, thus test the erase again::
root@1:~# mtd_debug erase /dev/mtd0 0 2097152
Erased 2097152 bytes from address 0x00000000 in flash
root@1:~# mtd_debug read /dev/mtd0 0 2097152 spi_read
Copied 2097152 bytes from address 0x00000000 in flash to spi_read
root@1:~# sha256sum spi*
4bda3a28f4ffe603c0ec1258c0034d65a1a0d35ab7bd523a834608adabf03cc5 spi_read
c444216a6ba2a4a66cccd60a0dd062bce4b865dd52b200ef5e21838c4b899ac8 spi_test
Dump some other relevant data::
root@1:~# mtd_debug info /dev/mtd0
mtd.type = MTD_NORFLASH
mtd.flags = MTD_CAP_NORFLASH
mtd.size = 8388608 (8M)
mtd.erasesize = 4096 (4K)
mtd.writesize = 1
mtd.oobsize = 0
regions = 0
Codebase Browser
linux