linux/drivers/ata/pata_ninja32.c

// SPDX-License-Identifier: GPL-2.0-only
/*
 * pata_ninja32.c 	- Ninja32 PATA for new ATA layer
 *			  (C) 2007 Red Hat Inc
 *
 * Note: The controller like many controllers has shared timings for
 * PIO and DMA. We thus flip to the DMA timings in dma_start and flip back
 * in the dma_stop function. Thus we actually don't need a set_dmamode
 * method as the PIO method is always called and will set the right PIO
 * timing parameters.
 *
 * The Ninja32 Cardbus is not a generic SFF controller. Instead it is
 * laid out as follows off BAR 0. This is based upon Mark Lord's delkin
 * driver and the extensive analysis done by the BSD developers, notably
 * ITOH Yasufumi.
 *
 *	Base + 0x00 IRQ Status
 *	Base + 0x01 IRQ control
 *	Base + 0x02 Chipset control
 *	Base + 0x03 Unknown
 *	Base + 0x04 VDMA and reset control + wait bits
 *	Base + 0x08 BMIMBA
 *	Base + 0x0C DMA Length
 *	Base + 0x10 Taskfile
 *	Base + 0x18 BMDMA Status ?
 *	Base + 0x1C
 *	Base + 0x1D Bus master control
 *		bit 0 = enable
 *		bit 1 = 0 write/1 read
 *		bit 2 = 1 sgtable
 *		bit 3 = go
 *		bit 4-6 wait bits
 *		bit 7 = done
 *	Base + 0x1E AltStatus
 *	Base + 0x1F timing register
 */

#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/blkdev.h>
#include <linux/delay.h>
#include <scsi/scsi_host.h>
#include <linux/libata.h>

#define DRV_NAME …
#define DRV_VERSION …


/**
 *	ninja32_set_piomode	-	set initial PIO mode data
 *	@ap: ATA interface
 *	@adev: ATA device
 *
 *	Called to do the PIO mode setup. Our timing registers are shared
 *	but we want to set the PIO timing by default.
 */

static void ninja32_set_piomode(struct ata_port *ap, struct ata_device *adev)
{ … }


static void ninja32_dev_select(struct ata_port *ap, unsigned int device)
{ … }

static const struct scsi_host_template ninja32_sht = …;

static struct ata_port_operations ninja32_port_ops = …;

static void ninja32_program(void __iomem *base)
{ … }

static int ninja32_init_one(struct pci_dev *dev, const struct pci_device_id *id)
{ … }

#ifdef CONFIG_PM_SLEEP
static int ninja32_reinit_one(struct pci_dev *pdev)
{ … }
#endif

static const struct pci_device_id ninja32[] = …;

static struct pci_driver ninja32_pci_driver = …;

module_pci_driver(…) …;

MODULE_AUTHOR(…) …;
MODULE_DESCRIPTION(…) …;
MODULE_LICENSE(…) …;
MODULE_DEVICE_TABLE(pci, ninja32);
MODULE_VERSION(…);