linux/drivers/net/wireless/mediatek/mt76/testmode.h

/* SPDX-License-Identifier: ISC */
/*
 * Copyright (C) 2020 Felix Fietkau <[email protected]>
 */
#ifndef __MT76_TESTMODE_H
#define __MT76_TESTMODE_H

#define MT76_TM_TIMEOUT

#include <net/netlink.h>

/**
 * enum mt76_testmode_attr - testmode attributes inside NL80211_ATTR_TESTDATA
 *
 * @MT76_TM_ATTR_UNSPEC: (invalid attribute)
 *
 * @MT76_TM_ATTR_RESET: reset parameters to default (flag)
 * @MT76_TM_ATTR_STATE: test state (u32), see &enum mt76_testmode_state
 *
 * @MT76_TM_ATTR_MTD_PART: mtd partition used for eeprom data (string)
 * @MT76_TM_ATTR_MTD_OFFSET: offset of eeprom data within the partition (u32)
 *
 * @MT76_TM_ATTR_TX_COUNT: configured number of frames to send when setting
 *	state to MT76_TM_STATE_TX_FRAMES (u32)
 * @MT76_TM_ATTR_TX_PENDING: pending frames during MT76_TM_STATE_TX_FRAMES (u32)
 * @MT76_TM_ATTR_TX_LENGTH: packet tx mpdu length (u32)
 * @MT76_TM_ATTR_TX_RATE_MODE: packet tx mode (u8, see &enum mt76_testmode_tx_mode)
 * @MT76_TM_ATTR_TX_RATE_NSS: packet tx number of spatial streams (u8)
 * @MT76_TM_ATTR_TX_RATE_IDX: packet tx rate/MCS index (u8)
 * @MT76_TM_ATTR_TX_RATE_SGI: packet tx use short guard interval (u8)
 * @MT76_TM_ATTR_TX_RATE_LDPC: packet tx enable LDPC (u8)
 * @MT76_TM_ATTR_TX_RATE_STBC: packet tx enable STBC (u8)
 * @MT76_TM_ATTR_TX_LTF: packet tx LTF, set 0 to 2 for 1x, 2x, and 4x LTF (u8)
 *
 * @MT76_TM_ATTR_TX_ANTENNA: tx antenna mask (u8)
 * @MT76_TM_ATTR_TX_POWER_CONTROL: enable tx power control (u8)
 * @MT76_TM_ATTR_TX_POWER: per-antenna tx power array (nested, u8 attrs)
 *
 * @MT76_TM_ATTR_FREQ_OFFSET: RF frequency offset (u32)
 *
 * @MT76_TM_ATTR_STATS: statistics (nested, see &enum mt76_testmode_stats_attr)
 *
 * @MT76_TM_ATTR_TX_SPE_IDX: tx spatial extension index (u8)
 *
 * @MT76_TM_ATTR_TX_DUTY_CYCLE: packet tx duty cycle (u8)
 * @MT76_TM_ATTR_TX_IPG: tx inter-packet gap, in unit of us (u32)
 * @MT76_TM_ATTR_TX_TIME: packet transmission time, in unit of us (u32)
 *
 * @MT76_TM_ATTR_DRV_DATA: driver specific netlink attrs (nested)
 *
 * @MT76_TM_ATTR_MAC_ADDRS: array of nested MAC addresses (nested)
 */
enum mt76_testmode_attr {};

/**
 * enum mt76_testmode_state - statistics attributes
 *
 * @MT76_TM_STATS_ATTR_TX_PENDING: pending tx frames (u32)
 * @MT76_TM_STATS_ATTR_TX_QUEUED: queued tx frames (u32)
 * @MT76_TM_STATS_ATTR_TX_QUEUED: completed tx frames (u32)
 *
 * @MT76_TM_STATS_ATTR_RX_PACKETS: number of rx packets (u64)
 * @MT76_TM_STATS_ATTR_RX_FCS_ERROR: number of rx packets with FCS error (u64)
 * @MT76_TM_STATS_ATTR_LAST_RX: information about the last received packet
 *	see &enum mt76_testmode_rx_attr
 */
enum mt76_testmode_stats_attr {};


/**
 * enum mt76_testmode_rx_attr - packet rx information
 *
 * @MT76_TM_RX_ATTR_FREQ_OFFSET: frequency offset (s32)
 * @MT76_TM_RX_ATTR_RCPI: received channel power indicator (array, u8)
 * @MT76_TM_RX_ATTR_IB_RSSI: internal inband RSSI (array, s8)
 * @MT76_TM_RX_ATTR_WB_RSSI: internal wideband RSSI (array, s8)
 * @MT76_TM_RX_ATTR_SNR: signal-to-noise ratio (u8)
 */
enum mt76_testmode_rx_attr {};

/**
 * enum mt76_testmode_state - phy test state
 *
 * @MT76_TM_STATE_OFF: test mode disabled (normal operation)
 * @MT76_TM_STATE_IDLE: test mode enabled, but idle
 * @MT76_TM_STATE_TX_FRAMES: send a fixed number of test frames
 * @MT76_TM_STATE_RX_FRAMES: receive packets and keep statistics
 * @MT76_TM_STATE_TX_CONT: waveform tx without time gap
 * @MT76_TM_STATE_ON: test mode enabled used in offload firmware
 */
enum mt76_testmode_state {};

/**
 * enum mt76_testmode_tx_mode - packet tx phy mode
 *
 * @MT76_TM_TX_MODE_CCK: legacy CCK mode
 * @MT76_TM_TX_MODE_OFDM: legacy OFDM mode
 * @MT76_TM_TX_MODE_HT: 802.11n MCS
 * @MT76_TM_TX_MODE_VHT: 802.11ac MCS
 * @MT76_TM_TX_MODE_HE_SU: 802.11ax single-user MIMO
 * @MT76_TM_TX_MODE_HE_EXT_SU: 802.11ax extended-range SU
 * @MT76_TM_TX_MODE_HE_TB: 802.11ax trigger-based
 * @MT76_TM_TX_MODE_HE_MU: 802.11ax multi-user MIMO
 */
enum mt76_testmode_tx_mode {};

extern const struct nla_policy mt76_tm_policy[NUM_MT76_TM_ATTRS];

#endif