/* SPDX-License-Identifier: GPL-2.0 */
/* Texas Instruments ICSSG Ethernet driver
*
* Copyright (C) 2022 Texas Instruments Incorporated - https://www.ti.com/
*
*/
#ifndef __NET_TI_ICSSG_SWITCH_MAP_H
#define __NET_TI_ICSSG_SWITCH_MAP_H
/************************* Ethernet Switch Constants *********************/
/* if bucket size is changed in firmware then this too should be changed
* because it directly impacts FDB ageing calculation
*/
#define NUMBER_OF_FDB_BUCKET_ENTRIES (4)
/* This is fixed in ICSSG */
#define SIZE_OF_FDB (2048)
#define FW_LINK_SPEED_1G (0x00)
#define FW_LINK_SPEED_100M (0x01)
#define FW_LINK_SPEED_10M (0x02)
#define FW_LINK_SPEED_HD (0x80)
/* Time after which FDB entries are checked for aged out values.
* Values are in nanoseconds
*/
#define FDB_AGEING_TIMEOUT_OFFSET 0x0014
/* Default VLAN tag for Host Port */
#define HOST_PORT_DF_VLAN_OFFSET 0x001C
/* Same as HOST_PORT_DF_VLAN_OFFSET */
#define EMAC_ICSSG_SWITCH_PORT0_DEFAULT_VLAN_OFFSET HOST_PORT_DF_VLAN_OFFSET
/* Default VLAN tag for P1 Port */
#define P1_PORT_DF_VLAN_OFFSET 0x0020
/* Same as P1_PORT_DF_VLAN_OFFSET */
#define EMAC_ICSSG_SWITCH_PORT1_DEFAULT_VLAN_OFFSET P1_PORT_DF_VLAN_OFFSET
/* default VLAN tag for P2 Port */
#define P2_PORT_DF_VLAN_OFFSET 0x0024
/* Same as P2_PORT_DF_VLAN_OFFSET */
#define EMAC_ICSSG_SWITCH_PORT2_DEFAULT_VLAN_OFFSET P2_PORT_DF_VLAN_OFFSET
/* VLAN-FID Table offset. 4096 VIDs. 2B per VID = 8KB = 0x2000 */
#define VLAN_STATIC_REG_TABLE_OFFSET 0x0100
/* VLAN-FID Table offset for EMAC */
#define EMAC_ICSSG_SWITCH_DEFAULT_VLAN_TABLE_OFFSET VLAN_STATIC_REG_TABLE_OFFSET
/* Packet descriptor Q reserved memory */
#define PORT_DESC0_HI 0x2104
/* Packet descriptor Q reserved memory */
#define PORT_DESC0_LO 0x2F6C
/* Packet descriptor Q reserved memory */
#define PORT_DESC1_HI 0x3DD4
/* Packet descriptor Q reserved memory */
#define PORT_DESC1_LO 0x4C3C
/* Packet descriptor Q reserved memory */
#define HOST_DESC0_HI 0x5AA4
/* Packet descriptor Q reserved memory */
#define HOST_DESC0_LO 0x5F0C
/* Packet descriptor Q reserved memory */
#define HOST_DESC1_HI 0x6374
/* Packet descriptor Q reserved memory */
#define HOST_DESC1_LO 0x67DC
/* Special packet descriptor Q reserved memory */
#define HOST_SPPD0 0x7AAC
/* Special acket descriptor Q reserved memory */
#define HOST_SPPD1 0x7EAC
/* IEP count cycle counter*/
#define TIMESYNC_FW_WC_CYCLECOUNT_OFFSET 0x83EC
/* IEP count hi roll over count */
#define TIMESYNC_FW_WC_HI_ROLLOVER_COUNT_OFFSET 0x83F4
/* IEP count hi sw counter */
#define TIMESYNC_FW_WC_COUNT_HI_SW_OFFSET_OFFSET 0x83F8
/* Set clock descriptor */
#define TIMESYNC_FW_WC_SETCLOCK_DESC_OFFSET 0x83FC
/* IEP count syncout reduction factor */
#define TIMESYNC_FW_WC_SYNCOUT_REDUCTION_FACTOR_OFFSET 0x843C
/* IEP count syncout reduction counter */
#define TIMESYNC_FW_WC_SYNCOUT_REDUCTION_COUNT_OFFSET 0x8440
/* IEP count syncout start time cycle counter */
#define TIMESYNC_FW_WC_SYNCOUT_START_TIME_CYCLECOUNT_OFFSET 0x8444
/* Control variable to generate SYNC1 */
#define TIMESYNC_FW_WC_ISOM_PIN_SIGNAL_EN_OFFSET 0x844C
/* SystemTime Sync0 periodicity */
#define TIMESYNC_FW_ST_SYNCOUT_PERIOD_OFFSET 0x8450
/* pktTxDelay for P1 = link speed dependent p1 mac delay + p1 phy delay */
#define TIMESYNC_FW_WC_PKTTXDELAY_P1_OFFSET 0x8454
/* pktTxDelay for P2 = link speed dependent p2 mac delay + p2 phy delay */
#define TIMESYNC_FW_WC_PKTTXDELAY_P2_OFFSET 0x8458
/* Set clock operation done signal for next task */
#define TIMESYNC_FW_SIG_PNFW_OFFSET 0x845C
/* Set clock operation done signal for next task */
#define TIMESYNC_FW_SIG_TIMESYNCFW_OFFSET 0x8460
/* New list is copied at this time */
#define TAS_CONFIG_CHANGE_TIME 0x000C
/* config change error counter */
#define TAS_CONFIG_CHANGE_ERROR_COUNTER 0x0014
/* TAS List update pending flag */
#define TAS_CONFIG_PENDING 0x0018
/* TAS list update trigger flag */
#define TAS_CONFIG_CHANGE 0x0019
/* List length for new TAS schedule */
#define TAS_ADMIN_LIST_LENGTH 0x001A
/* Currently active TAS list index */
#define TAS_ACTIVE_LIST_INDEX 0x001B
/* Cycle time for the new TAS schedule */
#define TAS_ADMIN_CYCLE_TIME 0x001C
/* Cycle counts remaining till the TAS list update */
#define TAS_CONFIG_CHANGE_CYCLE_COUNT 0x0020
/* Base Flow ID for sending Packets to Host for Slice0 */
#define PSI_L_REGULAR_FLOW_ID_BASE_OFFSET 0x0024
/* Same as PSI_L_REGULAR_FLOW_ID_BASE_OFFSET */
#define EMAC_ICSSG_SWITCH_PSI_L_REGULAR_FLOW_ID_BASE_OFFSET PSI_L_REGULAR_FLOW_ID_BASE_OFFSET
/* Base Flow ID for sending mgmt and Tx TS to Host for Slice0 */
#define PSI_L_MGMT_FLOW_ID_OFFSET 0x0026
/* Same as PSI_L_MGMT_FLOW_ID_OFFSET */
#define EMAC_ICSSG_SWITCH_PSI_L_MGMT_FLOW_ID_BASE_OFFSET PSI_L_MGMT_FLOW_ID_OFFSET
/* Queue number for Special Packets written here */
#define SPL_PKT_DEFAULT_PRIORITY 0x0028
/* Express Preemptible Queue Mask */
#define EXPRESS_PRE_EMPTIVE_Q_MASK 0x0029
/* Port1/Port2 Default Queue number for untagged Packets, only 1B is used */
#define QUEUE_NUM_UNTAGGED 0x002A
/* Stores the table used for priority regeneration. 1B per PCP/Queue */
#define PORT_Q_PRIORITY_REGEN_OFFSET 0x002C
/* For marking Packet as priority/express (this feature is disabled) or
* cut-through/S&F.
*/
#define EXPRESS_PRE_EMPTIVE_Q_MAP 0x0034
/* Stores the table used for priority mapping. 1B per PCP/Queue */
#define PORT_Q_PRIORITY_MAPPING_OFFSET 0x003C
/* Used to notify the FW of the current link speed */
#define PORT_LINK_SPEED_OFFSET 0x00A8
/* TAS gate mask for windows list0 */
#define TAS_GATE_MASK_LIST0 0x0100
/* TAS gate mask for windows list1 */
#define TAS_GATE_MASK_LIST1 0x0350
/* Memory to Enable/Disable Preemption on TX side */
#define PRE_EMPTION_ENABLE_TX 0x05A0
/* Active State of Preemption on TX side */
#define PRE_EMPTION_ACTIVE_TX 0x05A1
/* Memory to Enable/Disable Verify State Machine Preemption */
#define PRE_EMPTION_ENABLE_VERIFY 0x05A2
/* Verify Status of State Machine */
#define PRE_EMPTION_VERIFY_STATUS 0x05A3
/* Non Final Fragment Size supported by Link Partner */
#define PRE_EMPTION_ADD_FRAG_SIZE_REMOTE 0x05A4
/* Non Final Fragment Size supported by Firmware */
#define PRE_EMPTION_ADD_FRAG_SIZE_LOCAL 0x05A6
/* Time in ms the State machine waits for respond Packet */
#define PRE_EMPTION_VERIFY_TIME 0x05A8
/* Memory used for R30 related management commands */
#define MGR_R30_CMD_OFFSET 0x05AC
/* HW Buffer Pool0 base address */
#define BUFFER_POOL_0_ADDR_OFFSET 0x05BC
/* 16B for Host Egress MSMC Q (Pre-emptible) context */
#define HOST_RX_Q_PRE_CONTEXT_OFFSET 0x0684
/* Buffer for 8 FDB entries to be added by 'Add Multiple FDB entries IOCTL' */
#define FDB_CMD_BUFFER 0x0894
/* TAS queue max sdu length list */
#define TAS_QUEUE_MAX_SDU_LIST 0x08FA
/* Used by FW to generate random number with the SEED value */
#define HD_RAND_SEED_OFFSET 0x0934
/* 16B for Host Egress MSMC Q (Express) context */
#define HOST_RX_Q_EXP_CONTEXT_OFFSET 0x0940
/* Start of 32 bits PA_STAT counters */
#define PA_STAT_32b_START_OFFSET 0x0080
#endif /* __NET_TI_ICSSG_SWITCH_MAP_H */
Codebase Browser
linux