linux/Documentation/networking/device_drivers/ethernet/dec/dmfe.rst

.. SPDX-License-Identifier: GPL-2.0

==============================================================
Davicom DM9102(A)/DM9132/DM9801 fast ethernet driver for Linux
==============================================================

Note: This driver doesn't have a maintainer.


This program is free software; you can redistribute it and/or
modify it under the terms of the GNU General   Public License
as published by the Free Software Foundation; either version 2
of the License, or (at your option) any later version.

This program is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
GNU General Public License for more details.


This driver provides kernel support for Davicom DM9102(A)/DM9132/DM9801 ethernet cards ( CNET
10/100 ethernet cards uses Davicom chipset too, so this driver supports CNET cards too ).If you
didn't compile this driver as a module, it will automatically load itself on boot and print a
line similar to::

	dmfe: Davicom DM9xxx net driver, version 1.36.4 (2002-01-17)

If you compiled this driver as a module, you have to load it on boot.You can load it with command::

	insmod dmfe

This way it will autodetect the device mode.This is the suggested way to load the module.Or you can pass
a mode= setting to module while loading, like::

	insmod dmfe mode=0 # Force 10M Half Duplex
	insmod dmfe mode=1 # Force 100M Half Duplex
	insmod dmfe mode=4 # Force 10M Full Duplex
	insmod dmfe mode=5 # Force 100M Full Duplex

Next you should configure your network interface with a command similar to::

	ifconfig eth0 172.22.3.18
		      ^^^^^^^^^^^
		     Your IP Address

Then you may have to modify the default routing table with command::

	route add default eth0


Now your ethernet card should be up and running.


TODO:

- Implement pci_driver::suspend() and pci_driver::resume() power management methods.
- Check on 64 bit boxes.
- Check and fix on big endian boxes.
- Test and make sure PCI latency is now correct for all cases.


Authors:

Sten Wang <[email protected] >   : Original Author

Contributors:

- Marcelo Tosatti <[email protected]>
- Alan Cox <[email protected]>
- Jeff Garzik <[email protected]>
- Vojtech Pavlik <[email protected]>