/* SPDX-License-Identifier: GPL-2.0 */
/*
* xHCI host controller driver
*
* Copyright (C) 2008 Intel Corp.
*
* Author: Sarah Sharp
* Some code borrowed from the Linux EHCI driver.
*/
/* HC should halt within 16 ms, but use 32 ms as some hosts take longer */
#define XHCI_MAX_HALT_USEC (32 * 1000)
/* HC not running - set to 1 when run/stop bit is cleared. */
#define XHCI_STS_HALT (1<<0)
/* HCCPARAMS offset from PCI base address */
#define XHCI_HCC_PARAMS_OFFSET 0x10
/* HCCPARAMS contains the first extended capability pointer */
#define XHCI_HCC_EXT_CAPS(p) (((p)>>16)&0xffff)
/* Command and Status registers offset from the Operational Registers address */
#define XHCI_CMD_OFFSET 0x00
#define XHCI_STS_OFFSET 0x04
#define XHCI_MAX_EXT_CAPS 50
/* Capability Register */
/* bits 7:0 - how long is the Capabilities register */
#define XHCI_HC_LENGTH(p) (((p)>>00)&0x00ff)
/* Extended capability register fields */
#define XHCI_EXT_CAPS_ID(p) (((p)>>0)&0xff)
#define XHCI_EXT_CAPS_NEXT(p) (((p)>>8)&0xff)
#define XHCI_EXT_CAPS_VAL(p) ((p)>>16)
/* Extended capability IDs - ID 0 reserved */
#define XHCI_EXT_CAPS_LEGACY 1
#define XHCI_EXT_CAPS_PROTOCOL 2
#define XHCI_EXT_CAPS_PM 3
#define XHCI_EXT_CAPS_VIRT 4
#define XHCI_EXT_CAPS_ROUTE 5
/* IDs 6-9 reserved */
#define XHCI_EXT_CAPS_DEBUG 10
/* Vendor caps */
#define XHCI_EXT_CAPS_VENDOR_INTEL 192
#define XHCI_EXT_CAPS_INTEL_SPR_SHADOW 206
/* USB Legacy Support Capability - section 7.1.1 */
#define XHCI_HC_BIOS_OWNED (1 << 16)
#define XHCI_HC_OS_OWNED (1 << 24)
/* USB Legacy Support Capability - section 7.1.1 */
/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */
#define XHCI_LEGACY_SUPPORT_OFFSET (0x00)
/* USB Legacy Support Control and Status Register - section 7.1.2 */
/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */
#define XHCI_LEGACY_CONTROL_OFFSET (0x04)
/* bits 1:3, 5:12, and 17:19 need to be preserved; bits 21:28 should be zero */
#define XHCI_LEGACY_DISABLE_SMI ((0x7 << 1) + (0xff << 5) + (0x7 << 17))
#define XHCI_LEGACY_SMI_EVENTS (0x7 << 29)
/* USB 2.0 xHCI 0.96 L1C capability - section 7.2.2.1.3.2 */
#define XHCI_L1C (1 << 16)
/* USB 2.0 xHCI 1.0 hardware LMP capability - section 7.2.2.1.3.2 */
#define XHCI_HLC (1 << 19)
#define XHCI_BLC (1 << 20)
/* Intel SPR shadow capability */
#define XHCI_INTEL_SPR_ESS_PORT_OFFSET 0x8ac4 /* SuperSpeed port control */
#define XHCI_INTEL_SPR_TUNEN BIT(4) /* Tunnel mode enabled */
/* command register values to disable interrupts and halt the HC */
/* start/stop HC execution - do not write unless HC is halted*/
#define XHCI_CMD_RUN (1 << 0)
/* Event Interrupt Enable - get irq when EINT bit is set in USBSTS register */
#define XHCI_CMD_EIE (1 << 2)
/* Host System Error Interrupt Enable - get irq when HSEIE bit set in USBSTS */
#define XHCI_CMD_HSEIE (1 << 3)
/* Enable Wrap Event - '1' means xHC generates an event when MFINDEX wraps. */
#define XHCI_CMD_EWE (1 << 10)
#define XHCI_IRQS (XHCI_CMD_EIE | XHCI_CMD_HSEIE | XHCI_CMD_EWE)
/* true: Controller Not Ready to accept doorbell or op reg writes after reset */
#define XHCI_STS_CNR (1 << 11)
/**
* struct xhci_protocol_caps
* @revision: major revision, minor revision, capability ID,
* and next capability pointer.
* @name_string: Four ASCII characters to say which spec this xHC
* follows, typically "USB ".
* @port_info: Port offset, count, and protocol-defined information.
*/
struct xhci_protocol_caps {
u32 revision;
u32 name_string;
u32 port_info;
};
#define XHCI_EXT_PORT_MAJOR(x) (((x) >> 24) & 0xff)
#define XHCI_EXT_PORT_MINOR(x) (((x) >> 16) & 0xff)
#define XHCI_EXT_PORT_PSIC(x) (((x) >> 28) & 0x0f)
#define XHCI_EXT_PORT_OFF(x) ((x) & 0xff)
#define XHCI_EXT_PORT_COUNT(x) (((x) >> 8) & 0xff)
#define XHCI_EXT_PORT_PSIV(x) (((x) >> 0) & 0x0f)
#define XHCI_EXT_PORT_PSIE(x) (((x) >> 4) & 0x03)
#define XHCI_EXT_PORT_PLT(x) (((x) >> 6) & 0x03)
#define XHCI_EXT_PORT_PFD(x) (((x) >> 8) & 0x01)
#define XHCI_EXT_PORT_LP(x) (((x) >> 14) & 0x03)
#define XHCI_EXT_PORT_PSIM(x) (((x) >> 16) & 0xffff)
#include <linux/io.h>
/**
* Find the offset of the extended capabilities with capability ID id.
*
* @base PCI MMIO registers base address.
* @start address at which to start looking, (0 or HCC_PARAMS to start at
* beginning of list)
* @id Extended capability ID to search for, or 0 for the next
* capability
*
* Returns the offset of the next matching extended capability structure.
* Some capabilities can occur several times, e.g., the XHCI_EXT_CAPS_PROTOCOL,
* and this provides a way to find them all.
*/
static inline int xhci_find_next_ext_cap(void __iomem *base, u32 start, int id)
{
u32 val;
u32 next;
u32 offset;
offset = start;
if (!start || start == XHCI_HCC_PARAMS_OFFSET) {
val = readl(base + XHCI_HCC_PARAMS_OFFSET);
if (val == ~0)
return 0;
offset = XHCI_HCC_EXT_CAPS(val) << 2;
if (!offset)
return 0;
}
do {
val = readl(base + offset);
if (val == ~0)
return 0;
if (offset != start && (id == 0 || XHCI_EXT_CAPS_ID(val) == id))
return offset;
next = XHCI_EXT_CAPS_NEXT(val);
offset += next << 2;
} while (next);
return 0;
}
Codebase Browser
linux